top of page


Public·282 members
Raghuveer Sanchez
Raghuveer Sanchez

How to fix Acer A510 stuck at Fastboot USB download protocol

How to fix Acer A510 stuck at Fastboot USB download protocol

If you have an Acer Iconia Tab A510 that is stuck at the boot screen with the message "Booting failed Bootloader vJB-d0ca683: Starting Fastboot USB download protocol", you may be wondering how to fix it and restore your tablet to normal. This article will guide you through some possible solutions that may help you solve this problem.

First of all, you need to understand what Fastboot USB download protocol is and why it is showing up on your tablet. Fastboot is a mode that allows you to flash firmware or custom ROMs to your device using a USB cable and a computer. It is usually accessed by holding down a combination of buttons (such as Volume Down + Power) while turning on your device. However, sometimes your device may get stuck in Fastboot mode due to a corrupted bootloader, a faulty USB cable, or a software glitch.

acer a510 starting fastboot usb download protocol


When your device is stuck in Fastboot mode, it will display the message "Starting Fastboot USB download protocol" and wait for commands from your computer. However, if you don't have the proper drivers or tools installed on your computer, or if you don't know how to use them, you won't be able to communicate with your device and get out of Fastboot mode.

Therefore, the first thing you need to do is to install the necessary drivers and tools on your computer. You can download them from the following links:

  • Universal ADB Drivers [^1^]: This will allow your computer to recognize your device when it is connected via USB.

  • Minimal ADB and Fastboot [^2^]: This will allow you to execute commands on your device from your computer.

  • Official Jelly Bean ROM for Acer A510: This will allow you to flash the original firmware to your device in case it is corrupted or damaged.

After downloading and installing these files, you need to follow these steps:

  • Connect your device to your computer via USB cable.

  • Open Minimal ADB and Fastboot on your computer and type fastboot devices. This will show you if your device is detected by your computer. If it shows a serial number, then it means your device is recognized. If it shows nothing or an error message, then it means there is a problem with the drivers or the cable.

  • If your device is recognized, type fastboot reboot. This will try to reboot your device normally. If this works, then congratulations, you have fixed your problem. If not, proceed to the next step.

  • Type fastboot erase cache. This will try to clear the cache partition on your device, which may be causing some issues. If this works, then try rebooting again. If not, proceed to the next step.

  • Type fastboot flash system system.img. This will try to flash the official Jelly Bean ROM that you downloaded earlier to your device. Make sure that the system.img file is in the same folder as Minimal ADB and Fastboot. This may take some time, so be patient. If this works, then try rebooting again. If not, proceed to the next step.

  • Type fastboot oem unlock. This will try to unlock the bootloader on your device, which may be preventing you from flashing anything. This may wipe all your data on your device, so be careful. If this works, then try flashing the system.img file again and rebooting. If not, proceed to the next step.

Type fastboot boot recovery.img. This will try to boot into recovery mode on your device, which may allow you to perform a factory reset or restore a backup. Make sure that the recovery.img 0efd9a6b88


Welcome to the group! You can connect with other members, ge...


Group Page: Groups_SingleGroup
bottom of page